Recent content by fraenkg

I noticed that after the session was terminated, control was returned to the program, but it was no longer possible to execute it step by step in the debugger. A "run" always seems to be executed instead of a "step".

Thank you for the explanation regarding the difference between the 'old' service contract and the 'new' support contract and that the purchased version is licensed perpetually and can be operated independently of a support contract. Kind regards, Frank

As requested, I sent the current license information to support@allroundautomations.com Best regards Frank

I cannot use the current v15 activation for v16, even though the support contract runs until 2027. (see pictures)

I agree with the request.

This issue does not appear to be resolved in Beta 5. I think a correction is very important. Best Regards

This has been solved in beta 5, thanks!

... no only " Search List" and "Bookmarks". As already described, the menu option “View | Window list‿ activated. Disabling and re-enabling will make the window list available again.

What exactly is meant by "< or > button on the the tab list"? When I end the full screen mode with , the status is as shown in image 202410111. Tested in version 16.0.0.2134 beta (64 bit)

Point 2 has been corrected and now correctly shows "Loading Desktop". Point 1: Without change. The structure of the individual windows can still be observed and takes a considerable amount of time (probably also due to the constant rendering). Best regards

I assume that point "Leaving Full Screen mode would not restore all dockable tools correctly" from the release notes for Beta 4 refers to this thread. Unfortunately, my test did not reveal any change to the behavior described. Best regards

I noticed that the behavior when restarting with crach recovery is different from opening a workset. While the workset opens its windows invisibly (in the background) and then visualizes them, during a crash recovery each window is rendered and displayed individually. This obviously requires...

I see the same behavior in Beta 3 too Best regards

The problem is fixed for me with Beta 3. Thank you.

Thank you for changing the dialog text. However, I still have 2 comments. 1. Regardless of whether you want to remove the specification or the body with , you will see the same message: "Are you sure you want to close the tab?". Maybe you could specify the text? 2. If there is only one tab left...